Ad Radar
Circle Track

drive shaft ?

  
Item Posts    Sort Order

drive shaft ?

 
junkman69 junkman69
I watched NASCAR once | Posts: 3 | Joined: 04/13
Posted: 04/27/13
01:04 PM

hi i bought a older winged small block hilborn alc injected sprint car  i want to drive it on the street after i do lights muffers charging start  ect i got a 9 in tail shaft power glide automatic its  to long i put a short palatery gear in it  i got the 6 bolt cover an yoke  i pulled the torgue tube  an trans  i was going to install the yoke an cover an make a drive shaft  but the franklin rear has a female tube coming out so i was going to cut the origal inner drive shaft an tig on the yoke for the trans an slide the shaft in the rear  but with the torge tube out the franlin center section now can be rotated by hand  how do i fix the center section  from rotating ? thanks  

junkman69 junkman69
I watched NASCAR once | Posts: 3 | Joined: 04/13
Posted: 04/30/13
02:43 PM

hi any idears to fix ?  

waynep712222 waynep712222
I’ve been to a few races | Posts: 56 | Joined: 04/13
Posted: 05/08/13
11:37 AM

there are several articles spread out in the over 40 magazines on this site... on converted sprint cars to street cars...

it will take a while to dig them up...

i would probably look in hot rod mag...

click the source internet media icon below..  it will open a new window.. then click the our sites tab.. that gives you a complete list of magazines...

i am not hip on sprint car drivetrain... as there is only one circle track left anywhere close to los angeles.. and i don't get out that way often...