|
|
Item Posts
Sort Order
|
|
|
|
350 motor
|
racefan789
I watched NASCAR once
| Posts: 1
| Joined: 03/10
Posted: 03/03/10
06:58 PM
|
|
i was wondering if anybody can give me some advice on looking for a a good solid 350 chevy block and a good cam to use on a 3/8 mile dirt track in a 85 monte carlo ss (street stock division) with a .40 overbore and engine must be a 9:1 compression ratio. im just getting started and just looking for any advice
thanks
|
|
|
|
|
Posted: 03/31/10
01:43 PM
|
|
Check the classified section on racing websites, Craigslist and local paper for a good used 4 bolt block near you then bore it out. Just make sure there is no sign of rust caused by water standing in it.
As for the cam I like the solid lifter cams from speedwaymotors site. They list their cams based on what intake, carb, heads and RPM you run. PRC camshafts make nice power too, but I have had them fail during break-in if, I did'nt switch to low preasure valve springs and do atleast 3 times the break-in.
No matter what cam you choose don't forget to use a good cam break-in additive in the oil.
Go Fast Turn Left..
Taylor Racing Fan Page on Facebook.. http://www.facebook.com/pages/Taylor-Racing/301029283402
|
|
|
|
|
|
|
|
|